Makita DTR180 Instruction Manual page 21

3. Align the pipe of the tool with the groove inside the
wire guide B, and assemble them.
►
Fig.43: 1. Pipe 2. Groove 3. Wire guide B
4. Fix wire guide B by temporarily tightening bolt A.
►
Fig.44: 1. Bolt A 2. Wire guide B
5. Install the contact plate cover in the direction of the
arrow.
►
Fig.45: 1. Contact plate cover
6. Fix wire guide B and contact plate cover securely
by tightening bolt A and bolt B.
Error display and error tone
CAUTION:
During inspection, be sure to lock the trigger, turn the power off, and remove the battery
cartridge. Failure to do so may cause an accident.
CAUTION:
When you turn the power on, never bring your limbs or face close to the binding or rotating
parts of the tool tip. Otherwise, you
CAUTION:
When the power is turned on, never touch the binding or rotating parts of the tool tip.
Otherwise, you may
CAUTION:
If an error tone sounds, or if the tool malfunctions, immediately stop using the tool.
Error tone and display
If an error occurs, an error tone will sound, and an error number will be shown on the display panel. Refer to the
following table and take appropriate actions. If the error persists, ask Makita Authorized Service Centers for repairs.
Display
1
2
3
4
5
6
7
may
be injured.
Symptom
The tool stops operating.
The tool stops operating.
The tool does not perform the
tying process in continuous
actuation mode.
The tool does not start.
The tool stops operating.
The tool stops operating.
The tool stops operating.
The tool does not start.
The tool stops operating.
►
Fig.46:
cover
3. Bolt A 4. Bolt B
7. After assembling,
the
move
the
plate
NOTE: If the contact plate is caught, press it as shown
in
►
Fig.48
be injured.
Possible cause
The wire has been used up.
Tie wire is not loaded.
Wire feeding has failed.
The curl guide is open.
The contact plate is caught.
The battery has been
discharged.
The temperature of the battery
cartridge is abnormally high.
The motor is overloaded.
Motor failure
The temperature of the tool is
abnormally high.
Tool failure
21 ENGLISH
1. Wire guide B 2. Contact plate
confirm
contact plate
as shown
figure. ► Fig.47:
1. Contact
the figure.
Solution
Load new tie wire.
Load tie wire.
Check the orientation of the tie
wire.
Unload the tie wire, and load it
again.
Clean the path of wire.
Close the curl guide.
Release the contact plate from
being caught.
Recharge the battery.
Cool the battery cartridge
down.
Replace the battery cartridge
with a recharged one.
Determine the cause of the
obstruction of the motor rotation
and solve the problem.
Cool the tool down.
Ask Makita Authorized Service
Centers for repairs.
that
can
in