Honeywell FF-SB12 Series Installation Manual page 63

Fuse Replacement
The fuse is located near the relays above the electrical noise filter on the receiver unit (see figure 4-9). The
fuse is in the same location on the emitter power board.
1. Remove the power supply module as directed in the previous section.
Figure 4-9 Fuse
Fuse
Filter
2. Replace the fuse with a 0,5 amp, (120/240 Vac versions) or a 1 amp slow blow fuse (low voltage version).
3. Replace the power supply module.
4. Perform the operational test to ensure proper functional readiness.
70
107062-12 EN FR26 GLO 501 Printed in France