Installation In A Surface Mount/Flush Mount Housing / Programming - Honeywell Esser RZT 8000 Installation Instruction

4 Installation in a surface mount/flush mount housing /
programming

Pierce relevant cable entry

Fasten the cabinet on the relevant surface

Observe the specifications regarding electrical connection and insert the third-party detector connecting
module

Connecting cable for loop

Cable type as per national specifications:
e.g. communications cable I-Y (St) Y n x 2 x 0.8 mm or comparable and employ only shielded twisted
pair cables with special designation for fire detection

Connect third-party detectors

Use clearly identified cable I-Y (St) Y n x 2 x 0,8 mm and employ only shielded twisted pair cables with
special designation for fire detection, and consider furthermore the requirements of the local standard!

The shielding must be connected for EMI protection of the cable

The max. permissible loop resistor depends on the third-party detector

De-insulate and connect cables (The terminals are designed for conductor cross sections of 1.5 mm

The third-party connecting module is programmed with the service and programming software tools 8000
FB 789807.10 / 05.17
For easy installation the terminals of the third-party connecting module may be removed
with a suitable tool, such as long-nose pliers. When the loops have been connected,
attach the terminal strip to the plug contact again.
Refurbishment Zone Transponder RZT 8000
2
, max.)
21