ABB ACS 160 User Manual page 121

17
UNDERLOAD
18
19
20 **
AI OUT OF RANGE
21 - 29 **
HARDWARE ERROR
30
BR RES OVERLOAD
31
ENCODER FAULT
Full display blinking
Note! Faults (**) are indicated by a red blinking LED and are reset by turning the power off for a
while.
ACS 160 User's Manual
Motor load is too low. Check for a problem in the driven equipment.
Refer to parameters 3013 – 3015.
Reserved
Reserved.
Analogue input out of range. Check AI level.
Hardware error. Contact supplier.
Brake resistor is overloaded. Refer to parameter 2005
Positioning macro is used, but the drive is not receiving pulses. Check
the encoder and its connections.
Serial link failure. Bad connection between the control panel and the
ACS 160.
.
OVERVOLT CTRL
111