Advertisement
Quick Links
Advertisement
Related Manuals for Honeywell datamax-o'neil M-Class Mark II
Summary of Contents for Honeywell datamax-o'neil M-Class Mark II
- Page 1 92-2499-01 Rev.C RFID Ready Option...
- Page 3 Overview This document describes the contents and installation of the M-Class Mark II RFID options. Only qualified service personnel should perform this installation. After verifying the kit contents and the tools needed, follow the steps below to install the option. This RFID device complies with FCC Radio Frequency exposure limits for an •...
- Page 4 Contents The contents of the kit differ according to the type of RFID option: HF Option*: Antenna Regulator CCA Mounting Plate Power Cable Comm Cable Screw (3), M4 HD 8 Double-Sided Tape Screw, M4 HD 25 Short Spacer (2), .34 X .31 Long Spacer, .25 X .62 Washer RF Shield...
-
Page 5: Tools Required
Tools Required A Phillips screwdriver is needed, and a PC with an Internet connection may also be required. Step 1: Checking Firmware A) Verify the firmware version in the printer: Control Panel READY STOP ERROR WED 09:32A 23APR2008 Press the TEST Button on the Control Panel. READY Using the DOWN Button, scroll to PRINT PAUSE... - Page 6 Cover Screws B) Remove the Cover Screws on the outside of the printer. Cover Cover Screws C) Raise the Cover. Loosen the Cover Screws on the Centerplate Centerplate then remove the Cover. Printhead Latch D) Remove the Fascia, Printhead Assembly Thumbscrew and Tearbar (or other output attachment).
-
Page 7: Step 3: Installing The Option
Step 3: Installing the Option Double-Sided Tape A) Peel the backing from the Double-Sided Tape (Item 7). Affix the Double-Sided Tape to the recessed area of the Antenna Mount. If installing the HF Option, Antenna Mount proceed to B; otherwise, go to RF Sheild (HF Option, only) B) HF Option, only –... - Page 8 Antenna Cable Cableway Centerplate D) Route the Antenna Cable through the Cableway in the Centerplate. E) Loosen the Guide Screw Centerplate and the Heat Sink Screw then slide the Notched Tabs of the Mounting Plate (Item 3) Screw underneath. Secure the Guide Screw Notched Mounting Plate to the...
- Page 9 HF Option: G) Place the Washer (Item 11) and then the Long Spacer (Item 10) onto the Mounting Plate Screw (Item 8). Place a Short Short Spacer (Item 9) Spacer over the Long Spacer and Module Screw. Insert the Long Spacer and Screw Short Spacer...
- Page 10 UHF Option: G) Secure the UHF Module (Item 10) to the Mounting Plate using the four Standoffs (Item 11) and four Screws (Item 8). Screws Mounting Plate Module Standoffs Main Logic Regulator H) Route the Antenna Cable behind the Mounting Plate and then connect the cables according to the table Module...
- Page 11 Step 3: Returning Operation A) Dress the installed cables into the existing cable bundle. RECHECK ALL Cover Screws CONNECTIONS. Lower and latch the Printhead Assembly. Replace the Cover. Reinstall and tighten the three Cover Screws. Cover Screws B) Replace the Tearbar and Thumbscrew (or other output attachment).
- Page 12 Control Panel ERROR READY STOP USER MENU MEDIA SETTINGS D) Enable the option by following the instructions PRINT CONTROL PRINTER OPTIONS below: SYSTEM SETTINGS EXIT SYSTEM ENTER MENU TEST Step Instruction Displayed Message USER MENU Press the MENU Button on the Control Panel. MEDIA SETTINGS Using the DOWN Button, scroll to PRINTER PRINTER OPTIONS...