Table of Contents
Advertisement
Danger
When handling batteries
Do not disassemble or remodel.
Do not place a metal wire between the + and – pads. Do not carry with a hairpin or necklace.
Prohibited
Do not place in the fire or overheat.
Do not pierce with a nail, hit with a hammer or stamp down.
Or heat will be generated and the battery will ignite and explode.
Warning
When handling batteries
Do not disassemble, remodel, repair or charge.
Do not use a new and a used battery or two batteries of a different make together.
Prohibited
Do not mistake the + and – nodes when inserting the battery.
Do not leave used batteries in the device.
Or heat will be generated and the battery will ignite and explode.
When a battery leaks do not touch the liquid.
The liquid that leaks from a battery may burn. If the liquid gets on skin or clothing, wash with clean water.
If the liquid gets in your eye, wash with clean water immediately and seek medical treatment.
Contact
Prohibited
When changing the batteries, only used those which have been specified.
Using batteries other than that specified may result in the leakage of fluid, and the battery may ignite
and explode.
Strongly
Recommended
Make sure to observe the instructions of the computer and peripheral manufacturers when
installing and using the LinkTheater.
Strongly
Recommended
Do not attempt to disassemble or repair the LinkTheater.
This may result in fire or electric shock
Disassembly
Prohibited
Using the device with a different voltage such as may exist overseas, may result in a short circuit,
smoke or fire.
Only insert the plug into a 100V (50/60Hz) AC socket.
Prohibited
Insert the AC adapter firmly into the AC Socket.
Using the equipment without the AC Adapter firmly inserted may cause a short circuit or overheating, or
result in fire or electric shock.
Strongly
Recommended
Do not damage, process, overheat, or attempt to repair the power supply cable, as this may result
in fire or electric shock.
- When installing the equipment, do not crimp the power supply cable between walls and racks
Prohibited
(shelves) etc.
- Do not place heavy objects on the power supply cable, or pull at the cable.
- Do not place the power supply cable close to heat sources, or overheat the cable in any way.
- When removing the power supply cable, be sure to remove it my holding the plug.
- Do not bend the cable past its natural bending radius.
- Do not move the LinkTheater while the power supply cable is still connected.
If the power supply cable is damaged consult your dealer.
Install the equipment in a location where children cannot reach the interior of the electrical
equipment, cables, or connectors.
Failure to do so may result in injury.
Strongly
Recommended
4
Advertisement
Table of Contents
