Table of Contents
Advertisement
Setup Using Component Video:
Component Video Cable
(R)
(G) (B)
(W) (R)
Note: The LinkTheater's default TV Mode will not initially send video to the Component Video outputs, so all you'll
see on your TV at first is a blank screen. If your TV's input is set to 'Component', you can find the correct video-
out mode by pressing 'TV' and then 'Enter' on your Linktheater remote until you see the LinkTheater menu on your
TV. This will cycle through the different display modes available. Continue pressing 'TV' and then 'Enter' until the
best display is found. Turn to the next section of this manual for more information on configuring your display with
Component Video cables.
Setup Using Digital Audio:
If your A/V receiver has a digital audio input, you'll get better sound (and 5.1 support) if you connect the audio from
LinkTheater to the A/V receiver with either a toslink (optical) or RCA (coaxial) digital audio cable. You'll also need
to enable digital out in the LinkTheater's main options settings to complete the digital audio setup. Turn to the next
page to continue setting up LinkTheater.
Sound
Receiver
14
(R) (B) (G)
(W) (R)
Composite Audio Cable
Optical Digital Cable
Coaxial Digital Cable
Component
Audio
Video Connector
Connector
Coaxial
Optical
Advertisement
Table of Contents
