The Permanent (Locked) Beds In The Multi-Patient Viewer; Admitting A Patient - GE ApexPro Operator's Manual

The permanent (locked) beds in the multi-patient viewer

Admitting a patient

2001989-200E
4. Connect the monitor to an appropriate power outlet.
5. Turn on the monitor.
6. Wait 30 seconds, then verify the monitor displays the correct Unit Name and Bed
Name. If the Unit Name and Bed Name do not appear, refer to
the patient demographic information on page
7. Admit the patient to the monitor following the monitor's operator instructions.
During the installation of the CIC Pro center, qualified personnel may configure the
CIC Pro center to permanently display bed names in specific multi-patient viewer
locations (windows). These beds are locked into position and are always displayed
whether a patient is admitted to them or not. To change the display of locked beds,
contact your biomedical engineering department.
This section covers the following tasks:
Look for an empty patient window displaying an Admit button.
Enter the patient demographics.
Enter the bed number.
Enter the source of the ECG data.
Admit the patient.
NOTE
When the monitor moves from room to room and is not a transmitter, always
admit the patient at the monitor.
room on page 6-10.
Look for an empty patient window displaying an Admit
button
1. From the multi-patient viewer, look for an empty patient window displaying an
Admit button.
ApexPro™
6-14.
See The monitor moves (roves) from room to
Managing patients
To manually enter
6-11