Maintenance Mode
4 Network register
■ Click [Settings] then [Network register].
(1) Network register
1. Modify the necessary parts from Adapter name (this unit name), IP address, Subnet mask, Default
gateway.
2. Click on [Done].
3. The notification window will appear asking to re-connect 3 minutes or more. Click on [OK].
4. The Management application is completed.
5. It reconnects to this unit after 3 minutes or more.
The initial value of this unit is indicated in
the chart on the right.
NOTICE:
●
The Adapter name is written using alphanumeric characters. Special characters cannot be used.
●
The maximum limit for the Adapter name is 16 characters.
NOTE:
●
Please be careful about Network Security when performing a connection with the Internet.
Please contact the Administrator in charge of Network Security.
P5416904
Management Mode
< This item is not required but set if necessary at the install location. >
Control Mode
①
Address name
IP Address
Subnet Mask
Default Gateway
②
Control mode
192.168.0.3
255.255.255.0
192.168.0.1
23