Page 1
– INSTRUCTION MANUAL – ADVANCED COLOR WIRED REMOTE CONTROLLER MODELS PC-ARFG-E INSTRUCTION MANUAL PRIRUČNIK S UPUTAMA MANUAL DE INSTRUCCIONES NÁVOD K POUŽITÍ BEDIENUNGSANLEITUNG KÄYTTÖOPAS MANUEL D'INSTRUCTIONS HASZNÁLATI ÚTMUTATÓ MANUALE DI ISTRUZIONI INSTRUKCJA OBSŁUGI MANUAL DE INSTRUÇÕES MANUAL DE INSTRUCȚIUNI BRUGSANVISNING РУКОВОДСТВО...
• DO NOT perform installation work and electrical information or instructions to handle it properly wiring connection by yourself. Contact your and safely. Hitachi distributor or dealer and ask them for installation work and electrical wiring by a • Children should be supervised to ensure that service person. they do not play with the appliance.
Installation 2.1 INSTALLATION PROCEDURE • When Using Junction Box 1 Insert the edge of the slotted screwdriver into the groove at the bottom of the - Prepare the optional field-supplied holding bracket, push and turn the slotted Implanted Junction Box. screwdriver to separate and remove the - Feed the cable through the conduit controller from the holding bracket.
• Communication cabling must be a minimum 0.75 mm , 2-Conductor, Stranded Copper. Shielded cable must be considered for applications and routing in areas of high electronic interference (EMI) and other sources of potentially excessive electrical noise to reduce the potential for communication errors. When shielded cabling is applied, proper bonding and termination of the cable shield is required as per Johnson Controls-Hitachi Air Conditioning guidelines. Plenum and riser ratings for communication cables must be considered per application and local code requirements. The use of any other grade of cable other than that specified above can result in damage from EMI. • Keep a clearance of more than 30 cm between the transmission line (remote control switch cable and transmission wires) and the power source of indoor units. Otherwise, the air-conditioner may not operate properly or malfunction may occur due to the effect of power source noise.
Operation 4 OPERATION 4.1 OPERATION START/STOP 4.2 BASIC OPERATION Press “ ” (run/stop). The run indicator will 1 Wired controller Power ON. be turned on/off and the operation will be started or stopped accordingly. Connecting ... 2 Air Conditioner OFF When air conditioner is off, press “...
Operation 4.3 OPERATION MODE 3 Air Conditioner ON When air conditioner is on, press “ ” or “ ” Heating mode is only available when the to switch below items: indoor unit supports cooling and heating. “Temperature” ↔ “Mode” ↔ “Fan Speed” Cooling only machine cannot support ↔...
Operation 4.4 TEMPERATURE SETTING 2 By pressing “ ” or “ ”, the fan speed changes as follows. 1 Press “ ” or “ ” to select “Temp”. Auto ∧ ∨ High 2 ∧ ∨ High 1 ∧ ∨ ∧ ∨ Low 2 ∧...
Louver Swing Indicator Mode Indicator Menu Indicator Fan Speed Indicator Run Indicator OK Button On/Off Button Back Button Directional Key N O T E • The complete information about the purchased products is supplied in a CD-ROM, which can be found bundled with the outdoor unit. In case that the CD-ROM is missing or it is not readable, please contact your Hitachi dealer or distributor. • The backlight turns off 10 minutes after the last operation. If you press any switch, the backlight is turned on. (The switch pressed to turn on the backlight is not functional.) • Make sure to press the buttons lightly with your fingertips. • Do NOT press the buttons or anything with sharp points, such as a ball point pen. The operational functionality of the controller may become damaged. PMML0564 rev.1 - 09/2021...