Functional Description - Makita TD020D Instruction Manual

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before adjusting or
checking function on the tool.
Installing or removing battery cartridge
Fig.1
Always switch off the tool before insertion or
•
removal of the battery cartridge.
To remove the battery cartridge, withdraw it from
•
the tool while pressing the buttons on both sides of
the cartridge.
To insert the battery cartridge, align the tongue on
•
the battery cartridge with the groove in the housing
and slip it into place. Always insert it all the way
until it locks in place with a little click. If not, it may
accidentally fall out of the tool, causing injury to
you or someone around you.
Do not use force when inserting the battery
•
cartridge. If the cartridge does not slide in easily, it
is not being inserted correctly.
Lock button
Fig.2
When the lock button is in the locked position , the
switch cannot be actuated.
When the lock button is in the unlocked position , the
switch can be actuated.
Switch action
Fig.3
CAUTION:
Before inserting the battery cartridge into the tool,
•
always check to see that the switch actuates
properly and returns to the "OFF" position when
released.
To start the tool, first move the lock button to the
released position to release the switch.
simply push the switch on the
rotation and the
rotation Release the switch to stop.
CAUTION:
Always check the direction of rotation before
•
operation.
Change the direction only after the tool comes to a
•
complete stop. Changing the direction of rotation
before the tool stops may damage the tool.
When not operating the tool, always place the lock
•
button in the locked position .
side for the clockwise
side for the counterclockwise
Lighting up the front lamp
Fig.4
Fig.5
CAUTION:
Do not look in the light or see the source of light
•
directly.
To put on the light, first slide the lamp switch to the
position and then push the
Release it to stop.
NOTE:
When the lamp switch is in the locked position ,
•
lamp switch cannot be actuated.
CAUTION:
Always slide the lamp switch to the locked
•
position
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it may
lower the illumination.
ASSEMBLY
CAUTION:
Always be sure that the lock button is in the locked
•
position
removed before carrying out any work on the tool.
Installing or removing driver bit or socket bit
Fig.6
Use only the driver bit or socket bit shown in the figure.
Do not use any other driver bit or socket bit.
For European and North & South American
countries, Australia and New Zealand
A=12mm
B=9mm
And then
006348
For other countries
A=17mm
B=14mm
A=12mm
B=9mm
006349
1. To install the bit, pull the sleeve in the direction of
the arrow and insert the bit into the sleeve as far
as it will go. Then release the sleeve to secure the
5
mark on the lamp switch.
when not operating the tool.
mark and the battery cartridge is
Use only these type of bit. Follow the
procedure (1).
(Note) Bit-piece is not necessary.
To install these types of bits, follow
the procedure (1).
(Note) Makita bits are these types.
To install these types of bits, follow
the procedure (2).
(Note) Bit-piece is necessary for
installing the bit.