Makita HS301D Manual page 16

W
iring diagram
Fig. D-4
(17)
(10)
Two Lead wires (red), (black) connected to DC Motor
Put the following lead wires between Boss A and Boss B.
* Controller's lead wire (white) for connecting to Switch
* Controller's lead wire (yellow) for connecting to Terminal
* Controller's lead wire (red) for connecting to DC Motor
< Note> Lead wire (red) for connecting to DC Motor has to
be put on the other lead wires (white), (yellow).
Boss A
Wiring of Controller Unit
to DC Motor
Boss B
(10)
Put Controller (10) to Handle set R (17)
as follows.
* Facing its three lead wire side (white),
(yellow), (black) to the bottom of Handle
set R (17)
* Facing its two lead wire side (red), (black)
for connecting to DC motor, to Handle
set L side
Three Lead wires (white), (yellow), (black)
connected to Switch and Terminal
to Switch
to Terminal
The following lead wires has
to be put in this portion.
* Lead wire (black) for
connecting to DC Motor
* Lead wire (black) for
connecting to Terminal
P 16 / 17