Before Using Your Btd1 Tumble Dryer - Baumatic BTD1 Instruction Manual

BEFORE USING YOUR BTD1
TUMBLE DRYER
CAUTION: Ensure that the clothes you are about to dry are not
dripping wet.
- If you have not taken the clothes you want to dry out of a washing
machine with an adequate spin cycle, roll the clothes in a towel to
remove the excess water.
- Sort your clothes into groups of similar fabrics and colours. Check the
care label inside the garment you want to wash.
- Note that fabric conditioner reduces static electricity.
- Delicate articles (eg. Tights, stockings) should be placed inside a
pillowcase.
TO USE YOUR BTD1 TUMBLE DRYER:
1 Open the door.
2 Load clothes loosely into the drum (NOTE: Load sheets corner-first).
3 Close the door.
4 Dry your hands.
5 Select the desired heat position; either heat or full heat
(see the programme chart on facia panel).
6 Check that the timer is in the '0' position before you adjust it to the
drying time you want.
7 The drum will begin rotating.
8 It will stop when the timer automatically reaches the '0' position.
Note: you may remove your clothes before the completion of the
timed programme.
8
NOTE: Should the clothes become dry before the cycle has
finished, the thermostat will automatically switch off the heater
and prevent over-drying.
This will save energy, although the drum will
still rotate.
When drying large items (eg. Sheets) stop the dryer before the completion of a
programmed cycle and redistribute the load.
To stop the machine during the middle of a programme, simply open the door.
The drum will stop rotating automatically and reset when you close the door. To
lengthen or shorten the programme, turn the timer knob.
There is an automatic 12 minute cool down period at the end of every cycle,
during which the heater is switched off. This helps to minimise creasing.
9