Parts Description - Makita DVC560 Instruction Manual

12. Use the batteries only with the products
specified by Makita. Installing the batteries to
non-compliant products may result in a fire, exces-
sive heat, explosion, or leak of electrolyte.
13. If the tool is not used for a long period of time,
the battery must be removed from the tool.
14. During and after use, the battery cartridge may
take on heat which can cause burns or low
temperature burns. Pay attention to the han-
dling of hot battery cartridges.
15. Do not touch the terminal of the tool imme-
diately after use as it may get hot enough to
cause burns.
16. Do not allow chips, dust, or soil stuck into the
terminals, holes, and grooves of the battery
cartridge. It may result in poor performance or
breakdown of the tool or battery cartridge.
17. Unless the tool supports the use near
high-voltage electrical power lines, do not use
the battery cartridge near high-voltage electri-
cal power lines. It may result in a malfunction or
breakdown of the tool or battery cartridge.
18. Keep the battery away from children.
SAVE THESE INSTRUCTIONS.

PARTS DESCRIPTION

► Fig.1
1 Handle
5 Indication panel
9 Lock (for battery cover)
13 Round brush
17 Suction hose
21 LED lamp
25 OFF button
29 Indicator for remaining
battery capacity
ASSEMBLY
CAUTION:
Always be sure that the appli-
ance is switched off and the battery cartridge
is removed before carrying out any work on the
appliance.
CAUTION:
Always wear dust mask during
assembly or maintenance.
2 Switch plate
6 Lever (for the dust box
cover)
10 Adjusting lever
14 Foot lever
18 Joint
22 Brushroll
26 Indicator of oparating
mode
30 Battery check / LED
lamp button
CAUTION:
Only use genuine Makita batteries.
Use of non-genuine Makita batteries, or batteries that
have been altered, may result in the battery bursting
causing fires, personal injury and damage. It will
also void the Makita warranty for the Makita tool and
charger.
Tips for maintaining maximum
battery life
1. Charge the battery cartridge before completely
discharged. Always stop tool operation and
charge the battery cartridge when you notice
less tool power.
2. Never recharge a fully charged battery car-
tridge. Overcharging shortens the battery
service life.
3. Charge the battery cartridge with room tem-
perature at 10 °C - 40 °C (50 °F - 104 °F). Let
a hot battery cartridge cool down before
charging it.
4. When not using the battery cartridge, remove
it from the tool or the charger.
5. Charge the battery cartridge if you do not use
it for a long period (more than six months).
3 Pipe grip
7 Dust box cover
11 Battery cover
15 Caster wheel
19 Aluminum pipe
23 Bottom plate
27 Indicator of excess level
of dust
- -
Handle connecting
1. Insert the handle pole fully to the cleaner body as
shown in the figure.
2. Close the lock latch.
► Fig.2: 1. Handle pole 2. Red marking 3. Lock latch
NOTICE:
Insert the handle fully until the red
marking cannot be seen.
Hose connecting
Insert the hose into the mounting port of the appliance
and turn the horse until it locks.
► Fig.3
11 ENGLISH
4 Hose
8 Carrying handle
12 Corner nozzle
16 Side brush
20 Pipe holder
24 ON / mode change
button
28 Indicator of brushroll
error
- -