Honeywell PEHA 450 FU-SP 2 Installation And Operating Instructions Manual page 3

Transmitter board
Table of Contents

Advertisement

Available languages

Available languages

Elektro GmbH & Co. KG
450 Fu-sP 2
transmitter board, 2-channel
installation and operating
instructions
DescriPtiOn
The transmitter board module is part of the Easy-
click (EC) modular system developed by PEHA.The
system is based on radio transmitters and receivers
which operate at 868.3 MHz frequency, to wirelessly
control consumers. It is particularly well suited to
individual situations where the electrical installa-
tions should not be concealed in the wall, e.g. when
renovating, retrofitting electrical systems or in of-
fices with movable walls.
The transmitter board is suitable for installation in
conventional wall-mounted buttons. The board's
transmitters must be trained to the receivers. To
do this, refer to the operating instructions for the
radio receivers. Each transmitter board can control
an unlimited number of receivers.
notes:
– Read through the operating instructions carefully
before putting the device into service.
– O ne-button functions can only be performed
with Easyclick Plus receivers.
– The operating instructions for the radio trans-
mitters must be observed.
Vorsicht! Kontamination
Vorsicht, Gefahr durch
Vorsicht, Gefahr durch
sAFety
Abquetschen
Abschneiden
cAutiOn!
Danger of electrical shock! the housing
contains current-carrying components.
contact can lead to personal injury! All
Vorsicht, Gefahr durch
Vorsicht, Gefahr durch
Vorsicht, Gefahr durch
elektrischen Strom
elektromagnetische
explosionsgefährliche
Strahlung
Stoffe
work on the mains network and the de-
vice may only be performed by an autho-
rised electrician.
• Disconnect power supply from the device.
Vorsicht, Gefahr durch
Vorsicht, Gefahr durch
Vorsicht, Gefahr durch
• Secure the device against being powered on again.
Laserstrahlung
Radioaktivität
Rutschen
• Check that the device is powered off.
• Close the housing securely before applying power.
This device is only intended to be used for its stated
Vorsichtig verschieben!
Während der
Wandbrände nicht von
application. Unauthorised conversions, modifica-
- veraltet -
Schweißarbeiten,
oben löschen
Arbeitsstelle beobachten
tions or changes are not permissible! This device
may not be used in conjunction with other devices
whose operation could present a hazard to people,
animals or property.
Wandhydrant, mit Angabe
Wareneingang -
Wareneingang - Gesperrt
the following must be observed:
des Anschlusses
Freigegeben
• Prevailing statutes, standards and regulations.
• State-of-the-art technology at the time of
installation.
• The device's operating instructions.
• Operating instructions can only cite general
stipulations. These are to be viewed in the context
of a specific system.
technicAL inFOrMAtiOn
Operating fre-
868,3 MHZ
quency
transmission
10 mW
power
Modulation type
(ASK) Amplitude Shift Keying)
Operating
-25°C to +65°C
temperature
in dry rooms
Air humidity
0% bis 95 %
Batteries
2x Lithium Cell CR2032 3V
Dimensions
42 x 29 x 16 mm
PEHA_M_450 FU-SP2 (Rev02_130516)
rAnge
Radio signals are electromagnetic waves. The far-
ther away the transmitter is, the weaker is the field
strength surrounding the receiver. As such, the
range is limited. Different materials or interference
sources in the direction of the signals can further
reduce the range. The range can be increased by the
use of Easyclick Repeaters (radio amplifiers).
Material
Wood, plaster, non-coated glass
Masonry, wood/plaster walls
Reinforced concrete
Range
Under good conditions
> 30 m
(large, clear space without obstructions).
Through up to 5 plaster/drywall board walls or
2 plasterboard/partition walls (furniture and
> 20 m
people in the room):
For transmitter and receiver with good aerial
positioning/layout.
Through up to 5 plaster/drywall board walls or
2 plasterboard/partition walls (furniture and
people in the room):
> 10 m
For receivers installed in walls or corners of
rooms, receivers with internal aerial or nar-
row corridors.
Through 1-2
Depending on ceiling/wall armouring and
ceilings/ walls
type of aerial in the receiver.
note: Go to www.peha.de for further information on
"Range".
instALLAtiOn AnD cOMMissiOning
important installation information !
Installation and commissioning may only be per-
formed by an authorised electrician. Mains power
(230V~/50 Hz) to electrical equipment must be
Vorsicht, Gefahr durch
Abstürzen
switched off during installation. Applicable laws
and standards of the country in which the device is
operated must be observed!
Vorsicht, Gefahr durch
cOMMissiOning
feuergefährliche Stoffe
• Insert batteries (included)
• Configure the transmitter board.
• Train the board's transmitters to the receivers.
Vorsicht, Gefahr durch
Stolpern
terMinAL AssignMent
+
Wandbrände von unten
3V
nach oben löschen
Wärmeabzugseinrichtung
connection colours + button function
transmitter 1
transmitter 2
Aerial
earth (gnD)
126537-01
Reduction
0 - 10%
5 - 35%
10 - 90%
Conditions
Blue
black
red
grey
white
yellow
yellow = B utton O, Button 
white = Button I, Button 
red = Button O, Button 
grey = Button I, Button 
blue
black
instALLAtiOn
notes:
• N EVER install transmitters in a metal enclosure or
in the immediate vicinity of large metal objects.
• I nstallation close to floor level or on the floor is
not recommended.
single multi-circuit button
transmitter 2
red
grey
Double multi-circuit button
transmitter 1
yellow
white
transmitter 2
red
grey
earth
black
earth
black
gB-1

Advertisement

Table of Contents
loading

This manual is also suitable for:

00364956

Table of Contents