Switch Action - Makita SP6000 Instruction Manual

Tilting to the right
1
► 1 . Positive stopper
Turn the positive stopper so that the arrow on it points one of
two positions (vertical for 22.5°, horizontal for 45°). Loosen
the clamping screws in front and back. Then, tilt the tool base
until it stops and secure the base with the clamping screws.
To get 48° bevel angle, move the lever to 48° marking as
far as it will go. Turn the positive stopper so that the arrow
on it points to the horizontal position. Then, tilt the tool base
until it stops and secure the base with the clamping screws.
► 1 . Lever
Tilting to the left
1
► 1 . Bevel angle shifting lever
The tool can be tilted to the left 1° bevel angle. To get the
left 1° bevel angle, loosen the clamping screws in front
and back, tilt the tool handle slightly to the right and push
two bevel angle shifting levers at the same time in the
direction of arrow which has a marking -1. And then tilt the
tool handle to the left while pushing these two levers at the
same time. Secure the base with the clamping screws.
NOTE:
• Returning the blade to the right angle makes the
shifting lever return to 0° by itself.
Sighting
► 1 . Base 2. Cutting line
When using the tool without guide
1
rail (accessory)
For straight cuts, align the A position on the front of the base with
your cutting line. For 45° bevel cuts, align the B position with it.
When using the tool with guide rail
(accessory)
For both straight cuts and 45° bevel cuts, always align the
A position on the front of the base with your cutting line.

Switch action

2
► 1 . Lock-off button 2. Switch trigger
CAUTION:
• Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided. To start the tool,
push in the lock-off button and pull the switch trigger.
Release the switch trigger to stop.
7 ENGLISH
1
1
2
A
B