Functional Description; Adjusting Depth Of Cut; Bevel Cutting - Makita SP6000 Instruction Manual

WARNING:
DO NOT let comfort or familiarity
with product (gained from repeated use) replace
strict adherence to safety rules for the subject
product. MISUSE or failure to follow the safety
rules stated in this instruction manual may cause
serious personal injury.
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.

Adjusting depth of cut

2
► 1 . Clamping screw 2. Blade lower limit stopper
CAUTION:
• After adjusting the depth of cut, always tighten
the clamping screw securely.
Loosen the clamping screw on the depth guide and
move the blade lower limit stopper to the desired depth
on the scale plate. At the desired depth of cut, tighten
the clamping screw firmly.
For cleaner, safer cuts, set cut depth so that no more
than one blade tooth projects below workpiece. Using
proper cut depth helps to reduce potential for danger-
ous KICKBACKS which can cause personal injury.
NOTE:
• Setting the blade lower limit stopper to the
desired depth on the scale plate allows rough
depth of cut. For accurate depth of cut, measure
the actual protrusion of saw blade below the tool
base.
Quick stop button for 2 to 3 mm
depth of cut when using guide rail
(accessory)
► 1 . Quick stop button
This tool has the quick stop button for 2 to 3 mm depth
of cut on the gear housing aside the rear handle when
using guide rail. This is used when avoiding splinter on
the workpiece in the cut. Make a pass of the 2 to 3 mm
1
first cut and then make another pass of usual cut.
To obtain the 2 to 3 mm depth of cut, push in the stop
button toward the saw blade. This is convenient for
avoiding splinter on the workpiece.
To release the depth of cut from this position for free
depth of cut, just pull the button back.
► 1 . Quick stop button

Bevel cutting

1
► 1 . Clamping screws 2. Tool base
6 ENGLISH
1
1
1
2