Specifications - Makita GD0601 Nstruction Manual

ENGLISH (Original instructions)
1-1. Slide switch
2-1. Wrench 13

SPECIFICATIONS

Max. collet capacity
Wheel Point
No load speed (n
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for grinding ferrous materials or
deburring castings.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Uncertainty (K) : 3 dB (A)
The noise level under working may exceed 80 dB (A).
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode : surface grinding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
Explanation of general view
2-2. Collet nut
2-3. Wrench 13
Model
Max. wheel diameter
Max. mandrel (shank) length
) / Rated speed (n)
0
Overall length
Net weight
Safety class
noise level determined
) : 75 dB (A)
pA
value (tri-axial vector
2
) : 2.5 m/s or less
h,SG
2
ENE050-1
The declared vibration emission value is used for
•
main applications of the power tool. However if the
power tool is used for other applications, the
vibration emission value may be different.
ENF002-2
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
ENG905-1
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
Makita declares that the following Machine(s):
ENG900-1
Designation of Machine:
sum)
Die Grinder
Model No./ Type: GD0601
Conforms to the following European Directives:
2006/42/EC
They are manufactured in accordance with the following
standard or standardized documents:
ENG902-1
EN60745
The technical file in accordance with 2006/42/EC is
available from:
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
3
3-1. Side handle
GD0601
6 mm or 6.35 mm (1/4")
38 mm
46 mm
-1
25,000 min
359 mm
1.7 kg
/II
ENH101-18