Specifications - Makita LS0714 Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Model
Blade diameter
Hole (arbor) diameter (country specific)
Max. kerf thickness of the saw blade
Max. Miter angle
Max. Bevel angle
-1
No load speed (min )
Laser Type
Dimensions (L x W x H)
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s). The lightest and heaviest combination, according to
EPTA-Procedure 01/2014, are shown in the table.
Max. Cutting capacities (H x W) with blade 190 mm in diameter.
45° (left and right)
(Note)
* mark indicates that a wood facing with the following thickness is used.
1: When using a wood facing 20 mm thick.
2: When using a wood facing 15 mm thick.
3: When using a wood facing 10 mm thick.
Symbols
The following show the symbols used for the equip-
ment. Be sure that you understand their meaning before
use.
Read instruction manual.
DOUBLE INSULATION
To avoid injury from flying debris, keep
holding the saw head down, after making
cuts, until the blade has come to a com-
plete stop.
When performing slide cut, first pull car-
riage fully and press down handle, then
push carriage toward the guide fence.
Miter angle
0°
57° (right)
LS0714 LS0714F
-
670 mm x 430 mm x 458 mm
12.5 - 14.2 kg 12.8 - 14.5 kg
45° (left)
* 45 mm x 265 mm
Note1
40 mm x 300 mm
* 45 mm x 185 mm
Note2
40 mm x 212 mm
-----
Do not place hand or fingers close to the
blade.
For your safety, remove the chips, small
pieces, etc. from the table top before
operation.
Always set SUB-FENCE to left position
when performing left bevel cuts. Failure to
do so may cause serious injury to operator.
To loosen the bolt, turn it clockwise.
Never look into the laser beam. Direct laser
beam may injure your eyes.
11 ENGLISH
LS0714FL
190 mm
20 mm or 15.88 mm
2.2 mm
Left 47° , Right 57°
Left 45°, Right 5°
-1
6,400 min
Red Laser 650 nm, < 1mW
( Laser Class 2 )
12.9 - 14.6 kg
Bevel angle
0°
* 60 mm x 265 mm
Note 1
52 mm x 300 mm 40 mm x 300 mm
* 60 mm x 185 mm
Note 2
52 mm x 212 mm
* 60 mm x 145 mm
Note 3
52 mm x 163 mm
LS0714L
13.0 - 14.8 kg
5° (right)
-----
-----
-----