Startup - Honeywell HCI 300E Installation And Operation Manual

Startup

The HCI 300E can only be used via a telephone with DTMF
dialing*.
To start up the HCI 300E, you must remove the front cover (see
►
"Installing Hometronic Voice & Web Interface" on Page 52).
Connect the HCI 300E to the voltage supply by plugging the power
►
supply into an electrical outlet.
Both LEDs on the HCI 300E go on and off repeatedly. Both LEDs
go out after a short time.
If one of the LEDs does not go out, the cabling is not correct
(see "Connecting Hometronic Voice & Web Interface" on
Page 53).
Pick up the receiver of the telephone attached to the connection jack
►
of the HCI 300E.
A dial tone can be heard.
If a dial tone cannot be heard, the cabling is not correct (see
"Help with problems" on Page 80).
Perform binding.
►
Startup
57