ABB ACH580-01 Installation, Operation And Maintenance Manual page 51

ACH580 Installation, Operation and Maintenance Manual
Check that the motor data is correct. Values are
predefined on the basis of the drive size but you should
verify that they correspond to the motor.
Start with the motor type.
8
Go to the edit view of a selected row by pressing
Scroll the view with
Motor nominal cos Φ and nominal torque are optional.
Press
To change a value in an edit view:
Use
Use
9
Press
making changes.
This step is optional, and requires rotating the motor. Do
not do this if it could cause any risk, or if the mechanical
setup does not allow it.
10
To do the direction test, select Spin the motor and press
11 Press the Hand key
Check the direction of the motor.
If it is forward, select Yes, motor is spinning forward
12
and press
If the direction is not forward, select No, fix direction and
press
The first start is now complete and the drive is ready for
use.
13
Press
and .
(Next) to continue.
and to move the cursor left and right.
and to change the value.
(Save) to accept the new setting, or press
(Cancel) to go back to the previous view without
(Next).
on the panel to start the drive.
Hand
(Next) to continue.
(Next) to continue.
(Done) to enter the Home view.
.
ACH580-01 Installation
51