Advertisement
WARNING: To avoid water incursion on the female connector of the cable, make sure to use the supplied rubber caps to seal it off. In case the open
end of the cable gets wet, it might take a long time for the cable to be detected as Dry. Please leave the cable in a dry area for up to 2 hours and then
reconnect it to the sensor.
Testing the Connection
Once the device is mounted at the desired location and added to a network with a compatible gateway, press the General Purpose Button on the top of the
sensor to wake up the sensor and sync with the nearest gateway. Refer to
When the sensor is connecting to a gateway for the 1st time, it will blink Green LED which indicates that it is upgrading to the latest firmware
configured on the Dashboard
Support and Additional Information
If issues are encountered with device installation or additional help is required, contact Meraki Support by logging in to dashboard.meraki.com and opening a
case by visiting the Get Help section.
For additional information on Meraki hardware and for other installation guides, please refer to documentation.meraki.com.
LED Indicators
section for more details on the status of the sensor.
8
Advertisement
