Advertisement
1. Login to http://dashboard.meraki.com. If this is your first time, create a new account.
2. Find the network to which you plan to add your sensor or create a new network.
3.
Add
the sensors to your network. You will need your Meraki order number (found on your invoice) or the serial
number of each sensor, which looks like Qxxx-xxxx-xxxx, and is found on the back of the unit or included in the
box.
4. Add the gateway(MV or MR) to the same network as the sensor.
NOTE: Make sure the gateway is in the same network and is online and operational.
MV Set up Instructions
and
List of Compatible Gateways:
MV12(W/NE), MV22(X), MV32, MV72(X)
WARNING: Environmental Sensors are only supported with 2nd Gen MV Cameras and Wifi 6 Compatible APs
Minimum Firmware Version
MV
MT sensors can only connect to a compatible MV gateway running MV 4.8+. Please refer to
MR
In order to use a compatible MR device as a gateway for MT sensors, the Network in question should be set to MR27.5.11. This is a patch release that is based
off MR 27.5.1(latest stable) with additional support for MT sensors. Please refer to
MR Set up
Instructions.
MV
MR36, MR45, MR44 MR46, MR46E, MR55, MR56, MR76, MR86
Managing Firmware Upgrade
Managing Firmware Upgrade
to schedule an upgrade.
MR
to schedule an upgrade.
4
Advertisement
