Honeywell CNI4 Quick Start Manual page 2

Introduction
The CNI4 has two components: The Pulse
Accumulator and the Cloud Link 4G
Modem.
This Quick Start
instructions for using the MasterLink
Software (R510.1 or higher) to configure
the Pulse Accumulator and the Cloud Link
4G Modem as two independent sites, using
the USB-to-serial cable (40-6147-kit).
One end of the cable has a USB connector
and the other end includes a male and
female connector.
connector connects to the Cloud Link 4G
Modem and the female (green) connector
connects to the Pulse Accumulator.
Steps to configure the CNI4:
Step 1: Open the door of the CNI4 and install the SIM
Step 2: Power-up the CNI4 - battery or external power
Step 3: Connect the external pulse inputs (for wall mounted
Step 4: Disconnect the serial cable interfacing the Pulse Accumulator and the Cloud Link
Step 5: Configure the Pulse
Step 6: Configure the Cloud Link 4G
Step 7: Restore the original serial cable
Step 8: Close and lock the
Step 1: Open the door of the CNI4 and install the SIM Card
1. Lift the SIM card cover on the Cloud Link.
2. Slide the white SIM card holder to the right,
then lift the left edge.
3. Insert a SIM card into the slot provided and
close the card holder.
4. Slide the SIM card holder to the left until it
snap locks.
5. Close the cover.
CNI4 Quick Start Guide
Guide provides
The male (black)
Accumulator.
Modem.
connection.
door.
Pulse Accumulator
board
Connector to the
Pulse Accumulator
Connector to the
Cloud Link 4G
Modem
USB connection
to the PC
Card.
supply.
only).
Cloud Link 4G
Modem
2