Makita DTDA040 Series Instruction Manual page 12

Alarm No.
- Alarm for insufficient
fastening
- Alarm for limit of the
fastening capacity
- Maintenance alarm
- Alarm for no com-
munication with
the PC
- Indication that the
tool can communi-
cate with the PC
- Check for the lamp
and beeper (when
the battery cartridge
is installed)
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing driver bit/
socket bit
Optional accessory
Use only driver bit/socket bit that has inserting portion
shown in the figure. Do not use any other driver bit/
socket bit.
Function Status of the tool
The preset fas-
tening torque has
not been achieved
because the switch
trigger was released
before completing
the fastening.
–
The number of drive
has been reached to
your preset number
for the maintenance.
No data commu-
nication while the
tool is connected to
the PC.
The tool is con-
nected to the PC
and able to commu-
nicate with.
The tool performs
the operation test
for the LED indicator
(green/red), light,
and beeper.
Status of the LED indicator/beeper
LED indicator
Lights up in red for
approximately one
second.
Blinks in red quickly.
Blinks in yellow.
Blinks in yellow.
Blinks in green.
The LED indicator
lights up in green
and then red. After
that, the light turns
on for a while.
For tool with shallow driver bit hole
A=12mm
B=9mm
For tool with deep driver bit hole
A=17mm
B=14mm
A=12mm
B=9mm
1. To install the driver bit/socket bit, pull the sleeve in
the direction of the arrow and insert the driver bit/
socket bit into the sleeve as far as it will go.
Then release the sleeve to secure the driver bit/
socket bit.
1
► 1 . Driver bit 2. Sleeve
12 ENGLISH
Action to be taken
Beeper
A long beep Retighten the
fastener.
A series of long Replace the battery
beeps with fully charged
one.
– Reset the alarm
with the application
software.
– Restart the appli-
cation software and
re-connect the USB
cable.
–
A series of very
short beeps
Use only these type of driver
bit. Follow the procedure
1. (Note) Bit-piece is not
necessary.
To install these types of driver
bits, follow the procedure 1.
To install these types of driver
bits, follow the procedure 2.
(Note) Bit-piece is necessary
for installing the driver bit/
socket bit.
2
–
–