Removing The Release Element (Y56); Cooling Fan (M2/1) Removal (Up To Machine No. 10/59114003); Figure 012-8: Release Element Removal - Miele H 408 BM Series Technical Information

H 408x BM
4.4

Removing the Release Element (Y56)

1. Remove the appliance from its cabinet; see Section 011-4.3.
2. Remove the screws securing the appliance lid. Remove the lid.
Danger!
Before performing any service or repair work, discharge the high-voltage
capacitor. See Section A-2.
3. Disconnect the release element connections (Figure 012-8, Item 1).
4. Remove the screws securing the release element (Figure 012-8, Item 2).
5. Remove the release element (Figure 012-8, Item 3).

Figure 012-8: Release Element Removal

Danger!
After installation is completed, as a matter of standard practice, check the
oven for a tight seal with a microwave leak detector, paying particular attention
to the door and the housing edges.
4.5 Cooling Fan (M2/1) Removal
1. Remove the appliance from its cabinet; see Section 011-4.3.
2. Remove the screws securing the appliance lid. Remove the lid.
Danger!
Before performing any service or repair work, discharge the high-voltage
capacitor. See Section A-2.
3. Remove the rear air duct with cooling fan. See Section 012-4.2.
4. Remove the screws securing the cooling fan (Figure 012-5, Item 6).
5. Remove the cooling fan.
Danger!
After installation is completed, as a matter of standard practice, check the
oven for a tight seal with a microwave leak detector, paying particular attention
to the door and the housing edges.
(up to Machine No. 10/59114003)
33
Technical Information