Hitachi FL.NET User Manual page 12

(chapter 5, page 5-41)
When the self-node status area is set up, the self-node status flag is
transferred as 1-word data.
When the FA link status area is set up, the FA link status flag for the self-node
is transferred to the low-order byte of the specified area.
If the area for self-node status or FA link status information is not specified, the
FL.NET module cannot transfer the status information to the S10V.
(chapter 5, page 5-43)
The register/extension memory address range applicable to the higher layer
status area and FA link status area is the same as for the LPU memory
allocation area.
When the higher layer status area is set up, the contents of the higher layer
status flag are transferred as 1-word data.
When the FA link status area is set up, the contents of the FA link status flag
for the node are transferred to the low-order byte of the specified area.
The higher layer status/FA link status area setting must not be a duplicate of
the LPU memory allocation area setting for a remote node (reception setting)
or the self-node or of the setting for any other area.
If any node is omitted from the node settings given, the FL.NET module cannot
transfer the higher layer status or FA link status of that node to the S10V.
(chapter 5, page 5-46)
Do not mix to use C mode handler and mathematical/logical function.
Please be sure to unify either C mode handler or mathematical/logical function at
FL.NET module unit.
NOTICE
NOTICE
NOTICE
S-9