Rim Location Direction; Fixed The Tire - Bosch TCE 260 Operation Manual

en 14 | TCE 260 | Operation
You should be very careful when you break the
bead. When the blade moves, its speed is very fast and
the strength is very strong. In the area of its moving,
any objects will be under the danger of being crushed.
The clamping jaw on the turntable should be closed
completely.
When the clamping jaw is opened, if the opera-
tor undertakes bead breaking, this process will cause
danger to the operator. In this process, the hand should
not touch the pressed surface of the tire.
2. Lean the tire against rubber wheel support.
3. The surface of the blade will keep about 1cm from
the rim and the blade should rightly face the tire.
Pay attention to the position of the blade to avoid it
from touching the rim after bead breaking.
4. Step down blade control pedal 7-3 to make the blade
start working. When the bead is broken, release the
pedal at once.
5. Rotate the tire until the edge of the tire is detached
from the rim and repeat at the other side.
6. Spread some grease on the tire.
Not using the grease that will seriously damage
the tire. Please use the special grease.
|
1 987 AT7 374 2015-09-02
6.6

Rim location direction

How to decide from which side of the wheel to de-
mount tire?
1. When fix the wheel, the side of standard rim will
upward as figure.
2. Measure three dimension of A, B and C.
3. When fix the rim, the smallest size of C must be
positioned at the top position.
6.7

Fixed the tire

When the horizontal arm swings out, any one is
forbidden in the range of its movement.
R
Step down pedal 7-1, swing out the horizontal arm
and clean the turntable.
When lock the tire, it is absolutely forbidden to
put your hand under the tire. To correctly lock the tire,
you should position the tire at the very center of the
turntable.
R
Clamp the rim from outside:
$
Through step down the clamping jaw, open/ close
pedal 7-2 to control the open position of the
clamping jaw.
$
Place the tire on the clamping jaw, keep pressing
down the rim. Step down the pedal 7-2 until the
rim is locked.
During you position the tire on the turntable,
one operator is enough if the weigh is less than 25kg. If
the weight is 25kg-50kg, 2 persons will be enough. And
you will use the tire lifting device if the weight is exceed
50kg.
Robert Bosch GmbH