Maintenance �7; Suggested Lubricants; Cleaning And Servicing; Service Intervals - Bosch TCE 5310 Original Instructions Manual

6. Maintenance
6.�

Suggested lubricants

�omponent Lubricant
Gearbox ESSO Spartan EP460 ISO 460 DIN 51502-
Hydraulic pump ESSO NUTO H 46
Pneumatic sys- ESSO FEBIS K 32
tem (conditio-
ning assembly)
Tab. 1: Lubricants table.
!
The manufacturer is not liable for any damage
caused by use of lubricants different from those
shown in the table.
6.2 �leaning and servicing
Before any cleaning or maintenance interven-
tion, disconnect the TCE 5310 by means of
the main switch and disconnect the network.
To guarantee full efficiency of the TCE 5310 and to
ensure functioning without anomalies it is essential to
clean the machine regularly and carry out periodical
maintenance.
Maintenance has to be carried out by the operator
in accordance with the manufacturer's prescriptions
shown here below.
6.2.�

Service intervals

Maintenance
Clean the mechanical moving parts, spray
them with nebulized oil or kerosene and lubri-
cate with appropriate grease
Check transmission belt tensioning in order to
avoid its sliding.
Check the hydraulic control unit oil level and
keep it always between minimum and
Check and maintain the grease level on the
self-centering and on the tool holding arm.
Lubricate with grease the sliding rail of the
trolley.
Change the oil in the hydraulic control unit.
Check the gearbox oil level.
6.2.2 �heck the hydraulic control unit oil level
Robert Bosch GmbH
1. Power off the equipment.
2. Unscrew the cap with measuring rod on the hydrau-
3. Check that the oil level is between MIN and MAX.
Standard
6.2.�
CLP ISO 34-98-CC
1. Put a collecting tank underneath the gearbox.
ISO 46 DIN 51502-HLP
2. Unscrew the oil discharge screw.
DIN 51524 PART.2-
HLP ISO 67-43-HM
3. Discharge the gearbox oil and dispose of it (see
ISO VG 32
4. Screw the oil discharge screw.
5. Top up with new gearbox oil (see lubricant table).
6.�
Denomination
Rotary union
Anti-extrusion ring BR123
O-ring OR 123
Complete electrovalve 24V DC
Belt A33
4 position control lever
2 position switch
Nylon slider
x
x
x
x
x
x
x
Maintenance | T�� ���� | ��
lic control unit.

Gearbox oil change

chap. 7.3).

Spare and wearing parts

T�� ���� | �� | �� en
Order code
1 695 300 432
1 695 040 098
1 695 040 093
1 695 042 413
1 695 042 198
1 695 300 414
1 695 040 586
1 695 300 232
|
1 695 301 840 2011-07-14