Moving Your Appliance; Provision For Ventilation; For Your Safety; Location Of Appliance - Zanussi ZKG5030 User Manual

WARNING!
This appliance must be installed by a qualified
electrician / competent person (CORGI Regis-
tered). Safety may be impaired if installation is
not carried out in accordance with these in-
structions. Do not alter the electrical circuitry of
this appliance.

Provision for ventilation

• This appliance is not connected to a com-
bustion products evacuation device. It
should be installed and connected in ac-
cordance with the current installation regu-
lations. Particular attention should be given
to the relevant requirements regarding ven-
tilation.
• The room containing the appliance should
have an air supply in accordance with BS.
5440: Part 2 Current Edition. All rooms re-
quire an openable window or equivalent and
some rooms will require a permanent vent
as well. For room volumes up to 5m³ an air
vent of 100cm² is required: for room volumes
between 5m³ and 10m³ an air vent of 50cm²
is required. . If the room has a door that
opens directly to the outside, no air vent is
required. For room volumes that exceed
11m³ no air vent is required. If there are other
fuel burning appliances in the same room,
BS.5440: Part 2 Current Edition should be
consulted to determine the requisite air vent
requirements.
• Prolonged intensive use of the appliance
may call for additional ventilation, for exam-
ple opening a window, or more effective
ventilation, for example increasing the level
of mechanical ventilation where present.

Moving your appliance

• You may damage some soft or badly fitted
floor coverings when you move the appli-
ance. The floor covering under the appliance
should be securely fixed so it does not ruck
up when you move the appliance across it.
Alternatively you could remove the floor cov-
ering. This appliance is heavy and care must
be taken when moving it. Do not try to move
the appliance by pulling the door handles.
• To move the appliance, open the grill door.
Raise the appliance off its front feet by lifting
it from inside the oven. Pull the appliance
forward. When you replace the appliance
push it back to the stop and make sure there
is the same gap at each rear corner.

For your safety

• Do not try to disconnect the appliance from
the gas supply if the supply pipe does not
have a bayonet connection, as described in
the installation instructions. If this is the case
contact the person who installed the appli-
ance.

Location of appliance

• This appliance must not be installed in a bed-
sitting room of volume less than 20m³ or in
a bathroom, shower room or garage. It is
essential that the appliance is positioned as
shown.
29