Cleaning The Hob - Zanussi ZKG5030 User Manual

• Cleaners that contain bleach should not be
used as they may dull the surface finishes.
Harsh abrasives and scourers should also
be avoided.
Cleaning the outside of the
appliance
• Do not use abrasive cleaning materials e.g.
abrasive cream cleaners, wire wool pads or
scourers on painted or printed finishes as
damage may occur. Regularly wipe over the
control panel, control knobs, handles, doors
and appliance sides using a soft cloth and
hot soapy water. To prevent streaking, finish
with a soft cloth.
• Stainless Steel cream cleaners are abrasive
and should be avoided as they may dull the
surface finish. Any spillage on the stain-
less steel finish must be wiped off
immediately.
WARNING!
Do not attempt to remove any of the control
knobs from the appliance as this may cause
damage and is a safety hazard.

Cleaning the hob

• Clean the hob using a mild abrasive.
• Take care not to damage the spark electro-
des. If the spark electrodes are damaged the
burners will not light. You can remove the
pan supports, burner caps and burner
crowns to clean them. Again take care not
to damage the spark electrodes.
• Clean the burner crowns and pan supports
by soaking them in very hot soapy water.
22
• Aluminium based saucepans can leave
shiny metal marks on the pan supports. You
can remove any stubborn stains by scouring
with a soap impregnated steel wool pad. If
you look after the burner crowns and pan
supports in this way they will stay reasonably
clean. However the surface will dull with
time. After cleaning the appliance parts, dry
them thoroughly before you put them back.
When replacing hob burner parts
1. Crown to body. (Do not try to force the
crown on to the body). Make sure that the
hole in the crown is over the electrode.
Check that the location pegs sit in the slots
in the body. When the crown is in this po-
sition let it fall freely on to the body. Check
that the crown can be moved slightly from
side to side.
2. Cap to crown. Place cap centrally on the
top of crown (enamel side up). Move side-
ways and front to back to check the cap is
properly fitted.
3. Check for ignition. If a burner will not light
then you need to check the crown and cap
positions.