Connecting To Gas Supply - Zanussi ZKG5030 User Manual

• Curtains must not be fitted immediately be-
hind the appliance or within 150mm of the
sides of the hotplate. If fitted next to or be-
tween two base units a minimum space of
1mm must be left between each unit and the
sides of the appliance. The hob must be set
to a minimum of 7mm above the adjacent
units. (Note: The levelling feet fitted to the
appliance will achieve a nominal height of
907mm -5+ 13mm. Base units not meeting
the above conditions must be a minimum of
100mm away from the hob.
• For appliances installed in the Republic of
Ireland please refer to NSAI-Domestic Gas
Installation IS813 Current Edition Section7
Permitted Locations of appliance Table4---
Locations and Permanent Ventilation re-
quirements-flueless appliances. Note: -
L.P.G. cookers MUST NOT be installed
below ground level i.e. in a basement or
aboard any boat, yacht or other vessel.
30
min 150
min 7
min 1
Levelling the appliance
• Adjustment to suit floor conditions or height
is obtained by rotating clockwise or anti
clockwise the feet at the front and rear of the
appliance. A spirit level should be placed on
one of the shelves to confirm the appliance
is correctly levelled.

Connecting to gas supply

• This appliance is designed to be installed
with an appliance flexible connection only.
• Supply piping should not be less than R3/8.
Connection is made to the Rc ½ (½" B.S.P)
female threaded entry pipe located just be-
low the hob level on the rear left hand side
of the appliance.
IMPORTANT!
Only liquid sealants to be used when inlet gas
pipe is fitted i.e.: do not use P.T.F.E. sealant
tape.