Installation (For Toyota, Nissan Car Etc.); Installation (For Honda Acura Car) - Kenwood DPX-4010 Instruction Manual

Inst allat ion (f or TOY OTA , N ISSA N Car et c.)
2CA U TION
When performing a check of the CD operation prior to installation,
place this unit in a hirizontal position and perform a loading/eject
of the CD.
Installation
Install onto the car bracket using the supplied screw s (M 5 × 6
mm). The holes of the car bracket to use w ill differ depending on
the car model.
Accessory 2
(M 4 × 6 mm)
When a ground w ire is
included in the w iring kit
(w hich is sold separately),
fasten the ground w ire
w ith the binding screw
located on the rear panel
of this unit.
Accessory 3
(Only for NISSAN car)
Inst allat ion (f or HON D A A CU RA Car)
You can choose from three installation types to fit your car.
Perform "Assem bly" before installation.
Assembly
Fit the projections on both sides of the
Accessories 6 and 7 into the slits on
the Accessory 4 .
Bottom
panel
Accessory 1
or Accessory 0
(M 5 × 6 mm)
(The application
position of
Accessory 5 is at the
bottom panel)
— 31 —
Accessory 4
Accessory 0
(M 5 × 6 mm)
Accessory 7 (R)
Accessory 0
(M 5 × 6 mm)
Accessory 6 (L)