Fujitsu Airstage J-II Series Design & Technical Manual page 668

„ COMPLETION OF ADDRESS SETTING MODE
„
(21) Press and hold the "MANUAL/AUTO
button for 3 seconds.
MANUAL AUTO
IR RECEIVER UNIT
Each LED may be of a different brightness, but the content
¾
of the message does not change.
¾ The address setting signal is not received after switched address setting completion mode. (Pi Pi Pi Pi Pi)
„
¾ Press the "MANUAL/AUTO
„
setting mode.
„ RECONFIRMATION OF ADDRESS SETTING
„
(23) Press and hold the "FAN" and the " SET
TEMP. " buttons. While holding these 2
p
buttons, press the "RESET" button.
FAN
SET TEMP. ( )
RESET
z INDOOR UNIT ADDRESS SETTING
„
(24) Make sure the function number is "01"
Refer to (8)
Press the "TIMER set (-)" button.
"TIMER set (-)"
z REFRIGERANT CIRCUIT ADDRESS SETTING
„
(25) Make sure the function number is "02"
Refer to (15)
Press the "TIMER set (-)" button.
"TIMER set (-)"
" (22) Press the "RESET" button.
Pi Pi Pi
MANUAL
AUTO
" button again for 3 sec to return to if required to return to the address
Function setting
mode display
(Example) ADDRESS : 34
OPERATION LAMP
(GREEN)
TIMER LAMP
(ORANGE)
FILTER LAMP
(RED)
(Example) ADDRESS : 25
OPERATION LAMP
(GREEN)
TIMER LAMP
(ORANGE)
FILTER LAMP
(RED)
- (07 - 21) -
After pressing the RESET
button, set the custom code
again if b,c,d setting.
RESET
0.5sec ON / 0.5sec OFF
3 times 1 - 10 sec
0.5sec ON / 0.5sec OFF
4 times
1 - 10 sec
1sec ON / 1sec OFF
0.5sec ON / 0.5sec OFF
2 times 1 - 10 sec
0.5sec ON / 0.5sec OFF
1 - 10 sec
5 times