Advertisement
9.
Install dump-release lever using (1) M6-1 x 90
hex bolt, (2) spacers, and (1) M6-1 lock nut.
Use lower hole of lever (see Figure 10).
Important: Make sure slot in dump-release
lever fits over support brace, as shown in
Figure 11. The purpose of this slot is to
secure the support brace to the tongue.
Spacers
M6-1 X 90
Hex Bolt
Dump-Release
Lever
Figure 10. Dump-release lever installed with
spacers.
Dump-Release
Lever
Figure 11. Dump-release lever slot fitted over
support brace (viewed from below).
-4-
M6-1
Lock Nut
Lower
Hole
Slot
Support Brace
10. Hook one end of extension spring onto upper
hole of dump-release lever, then hook other
end of spring onto tongue, as shown in
Figure 12.
Upper
Hole
Figure 12. Dump-release extension spring
installed.
11. Position cart right-side-up.
12. Install bracket using (2) M8-1.25 x 20 hex
bolts, (2) 8mm lock washers, and (2) M8-1.25
hex nuts (see Figure 13).
13. Install hitch pin and secure with cotter pin, as
shown in Figure 13.
Note: This is a good place to store hitch pin
until you are ready to connect cart to towing
vehicle.
Bracket
Hitch Pin
Cotter Pin
Figure 13. Bracket installed and hitch pin
secured with cotter pin for storage.
T27708 250 lb. Poly Dump Cart (Mfd. 04/16)
Dump-Release
Extension Spring
x 2
Advertisement
