Advertisement
3.
Fully tighten fasteners from Step 1.
4.
Install both axle supports using (8) M8-1.25 x
16 Phillips head screws, (8) 8mm lock wash-
ers, and (8) M8-1.25 hex nuts (see Figure 6).
Do not fully tighten.
Note: Leave fasteners from Step 4 loose to
allow alignment of axle supports when install-
ing axle in Step 5.
Axle
Supports
x 4
Figure 6. Axle supports installed.
5.
Place tongue on support brace and align
axle holes of tongue and axle supports (see
Figure 7).
6.
Insert axle through both axle supports and
tongue (see Figure 7).
Holes Aligned
Support
Brace
Figure 7. Tongue and axle installed.
T27708 250 lb. Poly Dump Cart (Mfd. 04/16)
7.
Axle
8.
Tongue
Install (1) 17mm flat washer, (1) wheel, and
(1) 17mm flat washer onto each end of axle,
then secure wheels with cotter pins (see
Figure 8–9).
17mm Flat
Washer
Axle
Figure 8. Flat washer installed on axle.
17mm Flat
Wheel
Washer
Cotter Pin
Figure 9. Wheels installed.
Fully tighten fasteners from Step 4.
-3-
Advertisement
