Zone Configuration And Partition - GE NetworX Series Installation And Startup

ZONE CONFIGURATION AND PARTITION

IX.
The programming for all zone information is performed in the NetworX control panels (refer to Compatibility chart on
the back of this manual). For instructions on accessing and programming the control panel as well as changing the
characteristics of a configuration group, refer to the installation manual for the corresponding control panel. The
following programming information is taken from the NX-8 Installation Manual.
LOCATION 25 CONFIGURATION GROUP ZONES 1-8
(8 segments, numerical data) Location 25 contains the Configuration Group (Zone type) for zones 1-9. Segment 1
is for zone 1; Segment 8 is for zone 8. Default configurations are found in the table on page 7.
LOCATION 26 PARTITION SELECT ZONES 1-8
(8 segments, feature selection data) Location 26 is used to select the partition(s) that zones 1-8 reside in. A zone
may reside in any combination of the 8 partitions. If a burglary zone resides in more than 1 partition, it will only
be active when all partitions are armed. A zone that resides in more than 1 partition will be reported to its
lowest partition. Location 28 has 8 segments. Segment 1 corresponds to zone 1 and Segment 8 corresponds to
zone 8.
Segments 1 - 8:
1 = Partition # 1
2 = Partition # 2
LOCATIONS 27 – 36;
LOCATIONS 170 – 205 (Available on NX-8E only)
These locations contain the Configuration Group and Partition Select for Zones 9 – 192. Use the instructions
associated with Location 25 and 26 to program the remaining locations. Worksheets for these locations are
included for your convenience.
NX-216E Zone Expander
3 = Partition # 3
4 = Partition # 4
5 = Partition # 5
6 = Partition # 6
7 = Partition # 7
8 = Partition # 8
9