Dell PowerEdge FC830 Owner's Manual page 97

Installing the NDC
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the #2 Phillips screwdriver ready.
4. Remove the NDC.
CAUTION: To prevent damage to the NDC, hold the card only by its edges.
NOTE: You must remove the NDC to replace a faulty NDC or service other components inside the system.
Steps
1. Align the following:
a. The slots on the card edge with the projection tabs on the plastic bracket covering the tarjeta intermedia PCIe slots.
b. Screw holes on the card with the standoffs on the system board.
2. Lower the card into place until the card connector fits into the corresponding connector on the system board.
3. Secure the card with the two screws.
Figure 37. Installing the NDC
1. slot on the NDC
3. NDC
5. connector
2. screw (2)
4. standoff (2)
6. tab projections
Instalación y extracción de componentes del sled 97