Dell PowerEdge FC830 Owner's Manual page 71

Tareas relacionadas
Before working inside your system
Instalación de un procesador
Instalación de un disipador de calor
Installing a processor blank and DIMM blank
Después de trabajar en el interior de su equipo
Installing a processor blank and DIMM blank
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
NOTE: You must remove processor blank and DIMM blank when installing four processors or service other components
inside the system.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. If installed, remove the heat sink and the processor.
4. Ensure that the memory module socket ejectors are in the open position.
Steps
1. Align the processor blank and DIMM blank with the memory module sockets on the system board.
2. Lower the processor blank and DIMM blank onto the memory module sockets such that the bottom edges of the blank is
firmly inserted into the memory module sockets.
3. Press the blank firmly until the memory module socket ejectors click into place.
Figure 17. Installing a processor blank and DIMM blank
1. processor blank and DIMM blank
on page 51
on page 77
on page 78
on page 71
on page 51
2. tab on the processor blank and DIMM blank (4)
Instalación y extracción de componentes del sled 71