Dell PowerEdge FC830 Owner's Manual page 111

4. Remove the hard-drive or SSD cage.
NOTE: You must remove the hard-drive or SSD cage to replace a faulty hard-drive or SSD cage or service other
components inside the system.
Steps
1. Align the slots on the sides of the hard-drive or SSD cage with the standoffs on the chassis.
2. Lower the hard-drive or SSD cage into the chassis until the slots on the hard-drive or SSD cage engage with the standoffs
on the chassis.
3. Slide the hard-drive or SSD cage into the chassis until it clicks into position.
4. Install the two screws to secure the hard-drive or SSD cage to the chassis.
Figure 54. Installing the hard-drive or SSD cage
1. standoff (4)
3. screw (2)
Next steps
1. Install the hard-drive or SSD backplane.
2. Install the harddrive or SSD.
3. Follow the procedure listed in the After working inside your system section.Follow the procedure listed in the After working
inside your system section.
Related references
Instrucciones de seguridad
Related tasks
Before working inside your system
Removing the hard-drive or SSD cage
Después de trabajar en el interior de su equipo
on page 50
on page 51
on page 109
on page 51
2. hard-drive or SSD cage
4. screw hole (2)
Instalación y extracción de componentes del sled 111