Adjust The Ejector Chute; Operation; Switching On And Off; Practical Tips - Grizzly ESF 2046 L Translation Of The Original Instructions For Use

GB
the machine housing (11) and
screw this with the 4 enclosed
cross-head screws (26).
Mount shift linkage
2. Push the top shift rod (5) through
the opening in the plastic shroud
(22) on the central bar (7).
3. Release the fastening screw (27)
on the lower shift rod (9).
4. Push the top (5) and bottom
(9) shift rod together and screw
them with the fastening screw
(27).
5. Push the handle of the top shift
rod (5) in both directions. The
ejector chute (
able to move freely.

Adjust the ejector chute

The following settings are possible:
- Turning the ejector chute to the right or
left through a total of 190°;
- Tilting the ejector chute up or down
through 60°;
The steeper the ejector deflector (19),
the further the snow will be thrown.
1. Bring the ejector chute (16) into
the required direction by turning
the handle (5) of the shift link-
age.
2. Release the butterfly nuts (18)
on the ejector chute and fold the
ejector deflector (19) into the re-
quired position.

Operation

Switching ON and OFF

1. Make a loop in the end of the ex-
tension cable and suspend this
52
16) must be
in the cable strain relief (23).
2. Connect the machine to the
power supply.
The operating display (25) will
flash green.
3. To switch on press
the release button
(24) while holding
down the start han-
dle (2). Disengage the release
button.
The auger will start to turn.
4. To switch off re-
lease the start han-
dle (2).
Overload protection: The motor
will switch off automatically, if the
machine is overloaded. Release the
start handle and start the machine
again after it has cooled down.

Practical tips

After work and to transport: Switch
the machine off, disconnect the
power lead and ensure that all mov-
able parts have stopped moving.
There is a risk of personal injury.
Observe the noise protection and
local regulations.
• Work with care, especially if you
change the movement direction.
• Always keep the extension cable be-
hind you and place it on the area which
is ready when you turn.
• Move the machine slowly (at walking
speed) and in lines which should be
as straight as possible so that the lines
overlap a bit.
• We recommend that the machine
may be used for snow heights of up to
20 cm.
STOP START
I
3 2
STOP
3
1
START
1
I
2