Related Manuals for Epson S1D13709
Summary of Contents for Epson S1D13709
- Page 1 S1D13709 Embedded Memory Graphics LCD Controller S5U13709P00C100 Evaluation Board User Manual Rev.1.0 Document Number: xa8a-g-001 Status: Revision 1.0 Issue Date: July 31 2014 SEIKO EPSON CORPORATION...
- Page 2 2. This evaluation board/kit or development tool is intended for use by an electronics engineer and is not a consumer product. The user should use it properly and in a safe manner. Seiko Epson dose not assume any responsibility or liability of any kind of damage and/or fire caused by the use of it.
-
Page 3: Table Of Contents
Table of Contents 1. Introduction……………………………………..........4 2. Features……………………………………………………………………………5 3. Installation and Configuration…………………………………………………6 3.1. Switches………………………………………………………….…………6 3.2. Configuration Jumpers…………………………………………………….8 3.3. Power Supply………………………………………………..……………10 3.3.1 HIOVDD, NIOVDD, COREVDD, PLLVDD……………….….…10 3.3.2 Backlight Power Supply for LCD panel…………………………10 4. Connectors……………………………………………………………………….11 4.1 P1, P2 Host Interface Connector.............12 4.2 H1, H2 Host Interface Connector………………………….……….………12 4.3 H3, H4 Panel Interface Connector............12 5. -
Page 4: Introduction
1 Introduction This manual describes the setup and operation of the S5U13709P00C100 Rev.1.0 Evaluation Board. This evaluation board is designed as an evaluation platform for the S1D13709 Embedded Memory Graphics LCD Controller. The S5U13709P00C100 Evaluation Board can be used with the USB Interface Board (S5U13U00P00C100), thus providing an easy connection to Personal Computer with a USB interface. -
Page 5: Features
• Clock source can be selected from two types. Use on-board 24MHz crystal oscillator or set crystal in the 14pin socket. • SW1, SW2 are switches to change the configuration for the S1D13709. • On-board voltage regulator (LM1117MPX-3.3) with 3.3V output for HIOVDD/NIOVDD. -
Page 6: Installation And Configuration
The S5U13709P00C100 Evaluation Board incorporates DIP switches (SW1, SW2), which allow configuration of the board. For switch locations on the evaluation board, see Figure 3-1: “Configuration DIP Switches Location”. Figure 3-1: Configuration DIP Switches (SW1), (SW2) Location EPSON S5U13709P00C100 Evaluation Board User Manual Rev. 1.00... - Page 7 S5U13709 Evaluation Board User Manual The 12-position DIP switch (SW1) is used to configure the S1D13709 for different host bus interfaces and for TFT panel or STN panel for TFT-LCD Automatic Setting Mode. Table 3-1a: Summary of Configuration Options Configuration State...
-
Page 8: Configuration Jumpers
The 2-position DIP switch (SW2) is used to configure for production test only. For normal use this switch state should be set to "ON". Table 3-1b: Summary of Configuration Options S5U13709P00C100 Configuration State S1D13709 SW2-[2:1] 1 (ON) 0 (OFF) Configuration... - Page 9 Function Position1-2 No Jumper TPS61161A Enable Position3-4 No Jumper Vout = 20mA Position5-6 No Jumper Vout = 40mA ( and Position3-4) Position7-8 No Jumper Vout = 60mA (And position3-4/5-6) = default setting EPSON S5U13709P00C100 Evaluation Board User Manual Rev. 1.00...
-
Page 10: Power Supply
The S5U13709P00C100 Evaluation Board is possible to change the output current (20mA, 40mA, 60mA / Max 38V). Please set J1 with the specifications of the panel. Refer to Table 3-2c on page 9. EPSON S5U13709P00C100 Evaluation Board User Manual Rev. 1.00... -
Page 11: Connectors
The S5U13709P00C100 Evaluation Board has host interface connectors and panel interface connectors (P1, P2, H1, H2, H3 and H4). For connector locations on the evaluation board, see Figure 4-1: “Evaluation board Connector Location” Figure 4-1: Evaluation board Connector Location EPSON S5U13709P00C100 Evaluation Board User Manual Rev. 1.00... -
Page 12: P1, P2 Host Interface Connector
A windows driver must be installed on the PC when the S5U13709P00C100 is used with the S5U13U00P00C100 USB Interface Board. The S1D13xxxUSB driver is available at vdc.epson.com. 4.2 H1, H2 Host Interface Connector When the S5U13709P00C100 Evaluation Board connects with the S5U13U00P00C100 USB Interface Board, H1 and H2 connectors can be used as monitor terminals. -
Page 13: Technical Description
Table 3-2a and Table 3-2b on page 9. 5.3 Hardware Reset The S5U13709C00100 Evaluation Board has an on-board reset IC which drives the RESET# input pin on the panel. This occurs when push button SW3 is pressed. EPSON S5U13709P00C100 Evaluation Board User Manual Rev. 1.00... -
Page 14: Parts List
R32, R33, R34 Resister 10Ω SH1, SH2, SH3, SH4, SH5, SH6, SH7, SH8, SH9, SH10, SH11, Short socket XJ8A-0211 OMRON SH12, SH13, SH14, SH15, SH16 DIP switch 219-12MST DIP switch 219-2MST Switch KSC241J C&K EPSON S5U13709P00C100 Evaluation Board User Manual Rev. 1.00... - Page 15 Item Reference Part Description No. / Comments TP1, TP2, TP3 Monitor pin HK-2-S MAC8 T1, T2, T3, T4, T5, T6, Monitor TH S1D13709 EPSON Regulator LM1117MPX-3.3 LDE Driver TPS61161A Power Supply TPS3801K33DCKR Crystal FA-238 (24MHz) EPSON TOYOCOM EPSON S5U13709P00C100 Evaluation Board User Manual Rev. 1.00...
-
Page 16: Schematic Diagram
S5U13709 Evaluation Board User Manual 7 Schematic Diagrams Figure 7-1: S5U13709P00C100 Schematics (1 of 4) EPSON S5U13709P00C100 Evaluation Board User Manual Rev. 1.00... - Page 17 S5U13709 Evaluation Board User Manual Figure 7-1: S5U13709P00C100 Schematics (2of 4) EPSON S5U13709P00C100 Evaluation Board User Manual Rev. 1.00...
- Page 18 S5U13709 Evaluation Board User Manual Figure 7-1: S5U13709P00C100 Schematics (3of 4) EPSON S5U13709P00C100 Evaluation Board User Manual Rev. 1.00...
- Page 19 S5U13709 Evaluation Board User Manual Figure 7-1: S5U13709P00C100 Schematics (4of 4) EPSON S5U13709P00C100 Evaluation Board User Manual Rev. 1.00...
-
Page 20: S5U13709C00P100 Board Layout
S5U13709 Evaluation Board User Manual 8 S5U13709P00C100 Board Layout Figure 8-1: S5U13709P00C100 Board Layout – Parts Side EPSON S5U13709P00C100 Evaluation Board User Manual Rev. 1.00... -
Page 21: Reference
S5U13709 Evaluation Board User Manual 9 References 9.1 Documents • Epson Research and Development, Inc. , S1D13709Hardware Functional Specification, Document number XA8A-A-001 9.2 Document Sources • Epson Electronics America Website: http://vdc.epson.com EPSON S5U13709P00C100 Evaluation Board User Manual Rev. 1.00... -
Page 22: Appendix A Installation Guide For The S5U13U00C00P00
The following instructions are for connecting the S5U13709P00C100 Evaluation Board to the S5U13U00P00C100 USB Interface Board. The S5U13U00P00C100 is not included with the S5U13709P00C100 kit. Figure A-1: S5U13709P00C100 Evaluation Board Figure A-2: S5U13U00P00C100 USB Interface Board EPSON S5U13709P00C100 Evaluation Board User Manual Rev. 1.00... - Page 23 S5U13709 Evaluation Board User Manual 1. Download the S5U13U00P00C100 driver “S1d13xxx USB Evaluation Board Driver For Windows (2012-01-20)” from following link. http://vdc.epson.com/index.php?option=com_docman&task=cat_view&gid=125&Itemid=99. 2. Install the driver onto your PC. 3. Connect P1 on the S5U13709P00C100 with P1 on the S5U13U00P00C100, and P2 on the S5U13709P00C100 with P2 on the S5U13U00P00C100.
- Page 24 Figure A-4: Connecting S5U13U00P00C100 Board, USB cable and 5V power adapter 5. After connecting USB and 5V power supply, push hardware reset switch for both boards. The power is supplied from the S5U13709P00C100 to the S5U13U00P00C100. EPSON S5U13709P00C100 Evaluation Board User Manual Rev. 1.00...
-
Page 25: Appendix B Using The Panel I/F Board
Connect with the H3, H4 header of S5U13709 Evaluation Board and Panel I/F board. Please refer to figure B-2. Connect H3 header of S5U13709 board and CN2 connecter of panel I/F board. Connect H4 header of S5U13709 board and CN3 connecter of panel I/F board. EPSON S5U13709P00C100 Evaluation Board User Manual Rev. 1.00... - Page 26 S5U13709 Evaluation Board User Manual Figure B-2: Panel I/F board and S5U13709 board EPSON S5U13709P00C100 Evaluation Board User Manual Rev. 1.00...
- Page 27 S5U13709 Evaluation Board User Manual Figure B-3 Panel I/F board schematic EPSON S5U13709P00C100 Evaluation Board User Manual Rev. 1.00...
- Page 28 S5U13709 Evaluation Board User Manual Change Record EPSON S5U13709P00C100 Evaluation Board User Manual Rev. 1.00...
- Page 29 EPSON HONG KONG LTD. Unit 715-723, 7/F Trade Square, 681 Cheung Sha Wan Road, Kowloon, Hong Kong. Phone: +852-2585-4600 FAX: +852-2827-4346 EPSON TAIWAN TECHNOLOGY & TRADING LTD. 14F, No. 7, Song Ren Road, Taipei 110, TAIWAN Phone: +886-2-8786-6688 FAX: +886-2-8786-6660 EPSON SINGAPORE PTE., LTD.