Removing A Cisco Ucs Fabric Interconnect From A Rack - Cisco UCS 6400 Series Hardware Installation Manual

Replacing Components
Physical Switch Mgmt0 IP address : xx.xx.xx.xx
Apply and save the configuration (select 'no' if you want to re-enter)?
(yes/no): yes
Applying configuration. Please wait.
Fri Dec
Configuration file - Ok
Step 14 Enter the show cluster extended-state command to revalidate the cluster state and verify that HA is ready.
Example:
FI-A# show cluster extended-state
Cluster Id: 0x537d0580bf9911e0-0x8955000decd07984
A: UP, PRIMARY
B: UP, SUBORDINATE
A: memb state UP, lead state PRIMARY, mgmt services state: UP
B: memb state UP, lead state SUBORDINATE, mgmt services state: UP
heartbeat state PRIMARY_OK
INTERNAL NETWORK INTERFACES:
eth1, UP
eth2, UP
HA READY
Detailed state of the device selected for HA storage:
Chassis 1, serial: FOX1344G1R1, state: active
Chassis 2, serial: FOX1318GDKR, state: active
FI-A#
Step 15 Disable fabric evacuation and verify that traffic is flowing in both fabric interconnects.
Step 16
Apply the port license to the new fabric interconnect.

Removing a Cisco UCS Fabric Interconnect From a Rack

Caution Support both sides of the fabric interconnect when removing it from the rack. The slider rail and front
rack-mount brackets do not have a stop mechanism. If the front of the chassis is unfastened from the rack and
the chassis slides forward on the slider rails, it may slip off the end of the rails and fall out of the rack.
Procedure
Step 1
Ensure that the weight of the Cisco UCS Fabric Interconnect is fully supported and that the chassis is being
held by another person.
Step 2
Remove the two screws holding the grounding cable to the chassis (if installed).
Peer FI is IPv4 Cluster enabled. Please Provide Local
Fabric Interconnect Mgmt0 IPv4 Address
9 19:57:15 UTC 2016
<<<<<<<<<<<<<←---------------- HA is READY
Removing a Cisco UCS Fabric Interconnect From a Rack
Cisco UCS 6400 Series Fabric Interconnect Hardware Installation Guide
37