Cisco UCS 6400 Series Hardware Installation Manual page 34

Connecting to the Console Port
• Perform software recovery tasks when other connectivity is unavailable
• Monitor network statistics and errors
• Configure SNMP agent parameters
• Download software updates
Any device connected to this port must be capable of asynchronous transmission.
Before you begin
You may have to acquire some or all of the following:
• The Cisco serial console management cable.
• A USB to DB9 serial adapter and any drivers the adapter requires.
• Terminal emulation software such as PuTTY, HyperTerminal or Procomm Plus.
• A computer that can support VT100 terminal emulation.
Procedure
Step 1 Plug the RJ-45 end of the serial management cable into the console port on the fabric interconnect, and connect
the DB-9 male end into the serial port on a laptop or other computer.
If the computer you will use does not have a serial port, you will need to use the Serial to USB adapter. Be
sure to install the drivers for your adapter.
Step 2 Start your terminal software.
Step 3
Configure the terminal software as follows:
• The COM port for the connection you are about to establish is the connection to the fabric interconnect.
You may need to look in the computer's device manager to confirm this.
• The other connection parameters are 9600 baud, 8 data bits, no parity, 1 stop bit.
Step 4 Use the terminal software's command to open the connection to the fabric interconnect.
A session window will start and you will see one of the following prompts:
loader>
or
switch(boot)#
or
FI-A(local-mgmt)#
You now have terminal access. Depending on the prompt, you may have all Cisco UCS Manager CLI commands
or a very abbreviated set of configuration commands.
Cisco UCS 6400 Series Fabric Interconnect Hardware Installation Guide
28
Connecting the Cisco UCS Fabric Interconnect