35. Turn the three switch levers in the direction of arrow.
36. Open the inside SW cover and attach the inside panel assembly.
Note
To prevent the harness from being pinched, make sure that the harness does not overlap the positions of the holes of the screws,
the build-up harness guard, and the harness itself shown in the figure.
37. Push the three star-shaped marks, and then tighten the four screws with stopper.
Switch levers
Inside SW cover
Screw hole
Build up harness guard
Harness
Inside panel assembly
B3 x 10
(Screws with stopper)
Screw hole
Shield tube
16