31. Pull out the redundant part of the harness to the outside.
Note
Pull out the entire redundant part of the harness to the outside.
Redundant part of
the harness
32. Fix the harness (DC-OUT-POWER) with the two clampers as shown below.
Note
•
Pass the harness with a connector terminal (white) through the two clampers on the rear side as shown below.
•
Ensure an extra length of the harness of 12 cm or more from the rear clamper.
33. Attach the harness (DC-OUT- POWER) assembly, and then tighten the two screws.
Clampers
Extra length of the harness
of 12 cm or more
Harness (DC-OUT-POWER) assembly
PSW2 x 5
Connector terminal (white)
Harness (DC-OUT-POWER)
assembly
14