Start Up The System - Cisco TelePresence MX700 Installation Manual
Single camera on a free standing floor stand or a floor stand secured to the wall
Hide thumbs
Also See for TelePresence MX700:
- Reference manual (241 pages) ,
- Administrator's manual (141 pages) ,
- Installation manual (32 pages)
Advertisement
Installation guide for Cisco TelePresence MX700 Single camera - Floor stand
19
Start up the system
•
Remove the protection foil from the displays.
•
Make sure the camera can move freely.
•
Insert the network and power cables into the wall outlets.
•
Switch on the system.
The power switch is located directly below the codec, next to
the power connector.
Wait a few minutes while the system starts up. The start-up
may include automatic software upgrade and restart of
Touch controller and camera.
•
Follow the instructions on the Touch controller.
Cisco Webex: To find more information on how to get started,
visit
https://collaborationhelp.cisco.com
Started articles for room devices.
Other services: For further information on set-up and
configuration, download the Getting Started Guide from the
Cisco web site,
78-100218-03A0 | 2018 JUNE | © 2018 Cisco Systems, Inc. All rights reserved.
and look for Getting
https://www.cisco.com/go/mx-docs
Page 26
Advertisement
