Specifications; Intended Use; Power Supply - Makita LS1018 Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Model:
Blade diameter
Hole diameter
Max. kerf thickness of the saw blade
Max. miter angle
Max. bevel angle
No load speed (RPM)
Laser type
Dimensions (L x W x H)
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014
Max. Cutting capacities (H x W) with 260 mm in diameter
Symbols
The following show the symbols used for the equip-
ment. Be sure that you understand their meaning before
use.
Read instruction manual.
DOUBLE INSULATION
To avoid injury from flying debris, keep
holding the saw head down, after making
cuts, until the blade has come to a com-
plete stop.
When performing slide cut, first pull car-
riage fully and press down handle, then
push carriage toward the guide fence.
Do not place hand or fingers close to the
blade.
Adjust sliding fences clear of blade and
blade guard properly.
Always remove SUB-FENCE R when
performing right bevel cuts. Failure to do so
may cause serious injury to operator.
Countries other than Europe
European countries
Miter angle
0°
45°
60° (right)
LS1018
-
825 mm x 536 mm x 633 mm
45° (left)
50 mm x 310 mm
50 mm x 220 mm
-

Intended use

The tool is intended for accurate straight and miter
cutting in wood. With appropriate saw blades, aluminum
can also be sawed.

Power supply

The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
10 ENGLISH
LS1018L
255 - 260 mm
25.4 mm or 30 mm
(country specific)
30 mm
3.2 mm
Right 60°, Left 47°
Right 45°, Left 45°
-1
4,300 min
Red Laser 650 nm, Maximum output
1 mW ( Laser Class 2M )
21.5 kg
/II
Bevel angle
0°
91 mm x 310 mm 31 mm x 310 mm
91 mm x 220 mm 31 mm x 220 mm
91 mm x 153 mm
LASER RADIATION: Do not stare into
beam. Direct laser beam may injure your
eyes.
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of the European Directive,
on Waste Electric and Electronic
Equipment and its implementation in
accordance with national law, electric
equipment that have reached the end of
their life must be collected separately and
returned to an environmentally compatible
recycling facility.
45° (right)
-