Important Safety Information - Cisco AIR-PWRINJ-60RGD1 Series Installation Instructions Manual

Important Safety Information

FCC Compliance of Class B Devices
The following information is for FCC compliance of Class B devices:
The equipment described in this manual generates and may radiate radio-frequency energy. If it is not
installed in accordance with Cisco's installation instructions, it may cause interference with radio and
television reception. This equipment has been tested and found to comply with the limits for a Class B
digital device in accordance with the specifications in part 15 of the FCC rules. These specifications are
designed to provide reasonable protection against such interference in a residential installation.
However, there is no guarantee that interference will not occur in a particular installation.
Modifying the equipment without Cisco's written authorization may result in the equipment no longer
complying with FCC requirements for Class A or Class B digital devices. In that event, your right to use
the equipment may be limited by FCC regulations, and you may be required to correct any interference
to radio or television communications at your own expense.
You can determine whether your equipment is causing interference by turning it off. If the interference
stops, it was probably caused by the Cisco equipment or one of its peripheral devices. If the equipment
causes interference to radio or television reception, try to correct the interference by using one or more
of the following measures:
•
•
•
•
Modifications to this product not authorized by Cisco Systems, Inc. could void the FCC approval and
negate your authority to operate the product.
Important Safety Information
•
•
•
•
•
•
•
•
Cisco Aironet Series Power Injectors AIR-PWRINJ-60RGD1= and AIR-PWRINJ-60RGD2= Installation Instructions
4
Turn the television or radio antenna until the interference stops.
Move the equipment to one side or the other of the television or radio.
Move the equipment farther away from the television or radio.
Plug the equipment into an outlet that is on a different circuit from the television or radio. (That is,
make certain the equipment and the television or radio are on circuits controlled by different circuit
breakers or fuses.)
Installation and removal of the power injector must be carried out by qualified personnel only.
The power injector's "DATA IN" and "DATA PWR OUT" ports are shielded RJ45 data sockets. They
cannot be used as Plain Old Telephone Service (POTS) sockets. Only RJ45 data connectors can be
connected to these sockets.
Read the installation instructions before connecting the power injector to its power source.
Follow basic electricity safety measures whenever connecting the power injector to its power source.
A voltage mismatch can cause equipment damage and may pose a fire hazard. If the voltage
indicated on the label is different from the power outlet voltage, do not connect the power injector
to this power outlet.
The equipment is intended only for installation in a Restricted Access Location.
All wiring and connections shall be in accordance with NFPA 70 (NEC)
For AIR-PWRINJ-60RGD1=: This product is fitted with a NEMA 5-15P plug for connection to the
branch circuit. If other attachment methods are required, please reference local codes and
requirements for proper connection to the branch circuit.
For AIR-PWRINJ-60RGD2=: This product is fitted with a unterminated, 3-wire AC power cable.
Please refer to local codes for requirements for proper connection to the branch circuit.