Mounting The Power Injector On A Wall - Cisco AIR-PWRINJ-60RGD1 Series Installation Instructions Manual

Mounting the Power Injector on a Wall

Mounting the Power Injector on a Wall
Caution All mounting methods on any wall surface is subject to the acceptance of local jurisdiction.
You can mount the power injector to most vertical or horizontal surfaces. The power injector does not
ship with a mounting kit. You must provide the fasteners for the surface on which you intend to mount
the access point. An optional pole mount kit, AIR-PWRINJ-60-PMK=, is also available.
The power injector has three mounting holes, one on the top end and two on the bottom end, that you
can use to secure it to the surface. To mount the power injector using these screw holes, use three
fasteners of at least 1-3/8 inches (35mm) in length, or of the appropriate type for the surface on which
you are mounting the power injector on.
Though there are no ventilation openings on the power injector, you are recommended to keep some
Note
clearance around the front of the product.
To mount the power injector on a horizontal or vertical surface, follow these steps:
Use the power injector to mark the positions of the mounting tab holes on the surface where you want to
Step 1
mount the power injector. See
Drill holes at the locations you marked and insert the wall anchors. The holes need to be
Step 2
9/32_inches (7mm) long. Use M5 or #10 wall anchors.
Mount the power injector on the wall and align it with the screw holes. Use fasteners of at least
Step 3
1-3/8 inches inches (35mm) in length. Insert the fasteners into the mounting tab holes and tighten.
Ground the power injector, using the ground wire shipped with the power injector. Attach one end to the
Step 4
Earth Ground connector on the head of the power injector (see
permanent ground connection. The ground lug used is an M6 stud.
Step 5 Proceed with the
Cisco Aironet Series Power Injectors AIR-PWRINJ-60RGD1= and AIR-PWRINJ-60RGD2= Installation Instructions
8
Figure 4.
"Connecting Data and Power to the Injector" section on page
Figure 1), and attach then other end to a
11.